Truma AquaGo basic Instrucciones De Funcionamiento E Instalación página 10

Operating procedures
Risk of damage in frost conditions.
In frost conditions, ambient temperatures be-
low 39 °F (4 °C), there is a risk that water in pi-
pes, faucets and appliances could freeze. This
can cause considerable damage.
• Before you fill water into appliances and
parts that transport water, you must heat
the installation area sufficiently so that the
water cannot freeze.
Proceed as follows to fill the appliance with
water:
1. Close open bypass lines (if present). Insert
the water inlet filter or heating cartridge – if
removed. 2, 7, 9 – 11.
2. Turn on fresh water supply or switch on wa-
ter pump.
3. Fill the plumbing system.
• Open all water-release points, e.g., cold
and hot water faucets, showers, toilets.
It is important that you bleed the water
system before starting the appliance.
• Once water flows, the plumbing system
is vented. Close the water-release points.
4. Start the appliance as follows:
• Make sure that the LP gas supply is
turned on.
• Switch on the 12 V power supply (RV).
• Open the access door (refer to "Opening
the access door" on page 8).
• Switch on the appliance at the POWER
switch. Refer to "Switching ON the appli-
ance" on page 11.
5. AquaGo comfort / AquaGo comfort plus:
• Select the desired operating mode (refer
to "Operating modes (control panel)" on
page 11.
• Close the access door (refer to "Opening
the access door" on page 8).
10
Scalding injuries caused by hot water!
Water temperatures over 127ºF (52ºC) can
cause severe burns or scalding and in extreme
cases even death.
• Before using the hot water faucet or using
the shower, allow the hot water to run until
the water temperature no longer increases.
• Test the temperature of the water before
placing a child in the bath or shower.
• Do not leave a child or an infirm person in
the bath unsupervised.
• There may be a variation between the
temperature delivered from the ap-
pliance and the temperature at the
faucet due to water conditions or the
length of pipe from the appliance.
• The presence of a flow restrictor in the
hot water line may Iimit the water flow.
How to use hot water:
• To obtain the desired water temperature at
the faucet or in the shower, mix cold and hot
water.
• Particularly when showering, wait until the
water temperature has stabilized before en-
tering or allowing other people or animals to
enter the shower.