Switching ON the appliance
1. Open the access door (refer to "Opening the
access door" on page 8).
2. To switch on the appliance, switch the
POWER switch (Fig. 8 – 8) to one of the two
"ON" positions.
Both ON positions on the POWER switch
have the same function. Choose your
preferred position.
• When the green power ON LED 1 (Fig. 8 –
LED 1) is lit, the appliance is switched on.
• If the red error code LED 2 (Fig. 8 – LED 2)
is lit / flashes, there is a fault or warning
(refer to "APPENDIX A – Error Codes" on
page 37).
Fig. 8
AquaGo basic
• The operating mode is set automatically to
"BASIC".
• The appliance is now ready for use.
• Water temperature at the outlet is approxi-
mately 120 °F (49 °C).
AquaGo comfort / AquaGo comfort plus
• The appliance is now ready for using the
control panel inside your vehicle. Refer
to "Operating modes (control panel)" on
page 11.
LED 1
Power
8
Power
LED 2
Operating modes (control panel)
AquaGo comfort / AquaGo comfort plus
A control panel to select the operating mode
(included with the delivery from serial number
DLE60X(X)27100000).
Rotary switch
LED 3
Fig. 9
With the rotary switch (Fig. 9) you can choose
between the following operating modes:
Sign
Operating mode / Description
ECO
The appliance is now running in energy-
saving mode.
• Water temperature at the outlet is
approximately 120 °F (49 °C).
• Prevention of freezing by using
propane gas. The temperature in
the appliance is automatically kept
above 41 °F (5 °C) .
• During operation, the yellow status
LED 3 is lit.
COMFORT
The appliance is now running in a
mode that provides rapid availability of
hot water.
• Water temperature at the outlet is
approximately 120 °F (49 °C).
• Stand-by heat.
The temperature in the appliance
is automatically kept above 102 °F
(39 °C).
• During operation, the yellow status
LED 3 is lit.
Off
Stand-by. The appliance is not running
in any operating mode.
• The yellow status LED 3 is off.
To switch off the POWER and gas
supply refer to "Switching OFF
the appliance" on page 12.
Eco
O
Clean
11