Costway TQ10165 Manual Del Usuario página 6

Assembly Steps
• Your new motorcycle requires adult assembly. Please set aside at
least 40 minutes for assembly. Children can be harmed by small parts,
sharp edges and sharp points in the vehicle's unassembled state.
Care should be taken in unpacking and assembly of the vehicle.
Children should not handle parts, or help in assembly of the vehicle.
• Please identify all parts before assembly and save all packaging
material until assembly is complete to ensure that no parts are
discarded.
• Assembly tool for need: screwdriver(not included), pliers(not
included), hammer(not included), spanner.
1.Install the back wheel.
Screw
Fixings
Footrest B
Axle
• As shown in the picture, put the axle through the car body.
• Put the footrest B through the axle, and fasten with the screw.
• Put the footrest A through the axle, and fasten with the screw.
• As shown in the picture, install the fixings to the corresponding place,
and fasten with the screws.
• Install the capping board to the corresponding place, and fasten with
the screws.
10
Capping board
Screw
Fixings
Footrest A
2.Install the back wheel.
Wire
connector
Wheel hub
Nut
Washer
Gear box
Driving wheel Rear axle
• Turn over the car body, as shown in Figure 1, disconnect the rear
axle parts, keep one washer, then put the rear axle through the car
body.
• Put the gear box is arranged on the left, and the wire connector plug
butt.
• Put the driving wheel through the back axle.
• Put the washer, wheel through the back axle, then install washers to
both sides and fasten with nuts.
• Fix the wheel hub to both sides.
3.Install the fork.
Headlight
lineplug
•The headlight line plug butt.
•As shown in the picture, put the bolt through the fork, and tighten the
nut.
Washer
Nut
Wheel
Wheel hub
Fork
Bolt
Nut
11