Publicidad
5. HOW TO ASSEMBLE
4
Slide the desired SCREEN over the
exposed portion of the TWIN GEARS. See
page 12 for more information on which
SCREEN to select.
NOTE: Failure to properly seat the TWIN GEARS will prevent the LATCHES from shutting properly. If this is the case, remove the
OUTLET CASING and SCREEN; rotate the GEARS while pushing them in until they slide in completely and lock into position; and
reassemble. Damage to the machine due to improper assembly is not covered under your warranty.
7
Slide the JUICING KNOB or the
BREADSTICK KNOB (see page 12) into the
upper slot of the PULP OUTLET and turn
clockwise to screw it on. Tighten until it
comes to a comfortable stop. Do not over
tighten by forcing it to turn.
HOW TO DISASSEMBLE:
IMPORTANT: Make sure your Greenstar Juicer is switched off before disassembling the parts.
1. Unplug the POWER CORD from both the machine and
electrical outlet.
2. Remove the SAFETY HOOD by lifting it up.
3. Unscrew the JUICING KNOB or BREADSTICK KNOB by
turning it counterclockwise and slide it out.
4. Unlock the LATCHES on both sides by pulling on the metal
tabs. Open the LATCHES away from the OUTLET CASING.
5. Remove the OUTLET CASING by sliding it away from the
MAIN BODY. Note that the SCREEN and/or the TWIN GEARS
may come out with the OUTLET CASING.
5
Slide the OUTLET CASING over the
SCREEN.
8
Place the SAFETY HOOD over the FEEDING
CHUTE of the TWIN GEAR HOUSING. Gently
push down on the SAFETY HOOD until it
snaps into place.
6. Remove the SCREEN.
7. Carefully slide the TWIN GEARS out of the TWIN GEAR
HOUSING.
8. Remove the TWIN GEAR HOUSING by holding the FEEDING
CHUTE and sliding it away from the MAIN BODY.
NOTE: The TWIN GEARS on your juicer never need sharpening.
They are not blades. They work by 'biting' off small bits of
produce at a time, much like your teeth. They do not grate or
slice your produce, allowing them to work at remarkably low
speeds and preserving fragile nutrients and enzymes.
6
Close each LATCH over the ears of the
OUTLET CASING and snap the LATCHES
shut by pushing back on the metal tabs.
9
Attach the POWER CORD to the rear of the
MAIN BODY and plug the other end into an
electrical outlet.
EN
11
Publicidad
