CASUALPLAY S4 REVERSE Instrucciones De Uso página 15

WARNING: The S4 Reverse comes without the wheels on. Fit the rear wheels before
unfolding the pushchair for the first time.
FITTING THE REAR WHEELS (illustration 1)
• Fit the rear wheels by pressing the central button (A) and inserting the axle into the hole
of the rear wheel bearer (B). It will click when correctly fitted. Check that the wheel is
secure and turns freely.
• To remove the wheels follow the same steps in reverse order.
UNFOLDING (illustrations 2-3)
• Release the locking device (fig.2).
• Pull the handlebar until it clicks indicating it is locked into place correctly (fig.3). Make
sure that the locking device is securely fastened.
FITTING THE FRONT WHEELS (illustrations 4-6)
• Pull the front wheel axle support until a click indicates it is locked (fig.4).
• Fit the wheel group into its slot, pressing upwards until it clicks indicating it has been
inserted correctly (fig. 5).
• To remove the wheels, turn the wheel group until you can see the red release button.
Press it and pull the wheel group to take it off (fig.6).
LOCKING THE FRONT WHEELS (illustration 7)
• To prevent the front wheels from swivelling press the button situated between the two
wheels downwards. To unlock the wheels press the button upwards.
PARKING BRAKE FUNCTIONING (illustration 8).
• To put the brake on press the pedal situated between rear wheels downwards.
• To release the brake press the pedal upwards.
FITTING THE UNISYSTEM ADAPTORS FOR THE SEAT (illustrations 9-10)
• Fir the adaptors (A and B) into the corresponding Unisystem side slots (A and B). When
they are correctly fastened a green signal will appear in the side window of each adaptor
(fig.9).
• To take them off press the red buttons on each adaptor. A red signal in the side window
of the adaptors means you can now take them off (fig.10).
FITTING THE SEAT (illustrations 11-12)
• Put the parking brake on.
• Insert the connectors into the two slots of the side adaptors (fig.11).
• Make sure that the green signal appears in the window indicating it is correctly fastened
(fig.12). The child can now be seated.
FITTING THE ARMREST (illustrations 13-14)
• Insert the ends of the armrest into the front slots on the pushchair (fig.13).
• To remove the armrest press the buttons (A) on the lower part and pull the armrest (B)
upwards (fig.14).
INSTRUCTIONS FOR USE
13