Bianchi C4205982 Manual De Uso Y Mantenimiento página 6

QUALITY STANDARDS
The Wheels have been checked according to the Manufacturer's quality standard and tested in accordance with the industry standard
UNI EN 4210-7.
DESIGNATED INTENDED USE (ASTM)
CAUTION/IMPORTANT
The wheels are designed for exclusive use:
a) on bicycles with disc brakes and without a motor.
b) in the following categories: 1 and/or 2 and in the less severe category as defined by the ASTM (American Society for Testing and
Materials) standards, which take into account the stresses that the wheels themselves may face and the vehicles on which they may
be used.
(hereinafter, use (a) and (b) jointly referred to as "Designated Use").
* ASTM category
ASTM CATEGORY 1: Routes on paved roads. In short, this category includes all the
bikes and components, including wheels, designed for use on smooth surfaces, and where therefore
both tires remain in contact with the ground.
List of Reparto Corse wheels in the ASTM1 category
- RC 65R SPB ETRTO 622 x 21C (Rear Code C4205982)
TECH
- RC 50R SPB ETRTO 622 x 21C (Front Code C4105964)
TECH
- RC 50R ETRTO 622 x 21C (Front Code C4105984 / Rear Code C4206001)
- RC 33R ETRTO 622 x 21C (Front Code C4105983 / Rear Code C4206121)
CERAMITEC
ASTM CATEGORY 2: Paved and off-road routes with drops of less than 15 cm.
This type of use includes bicycles and components that can be used in Category 1 or on dirt roads (gravel roads).
Whether on road or uneven terrain, loss of contact with the ground and the resulting jump and/or drop should not
exceed 15 cm in height.
It is therefore recommended that these wheels be used in the conditions for which they are intended or for less
severe conditions of use.
List of Reparto Corse wheels in the ASTM2 category
- RC 43 ETRTO 622 x 24C (Front Code C4106010 / Rear Code C4206137)
CERAMITEC
WARNING/SAFETY RULE
Any use of the Wheels other than Designated Use is prohibited.
6