Bianchi C4205982 Manual De Uso Y Mantenimiento página 8

TUBELESS READY TAPE REPLACEMENT PROCEDURE
It is recommended that you strictly follow the instructions provided by the Tubeless Ready tire manufacturer as well as the following
general instructions if the Tubeless Ready sealing tape needs to be replaced:
1. Remove the tape previously affixed to the rim, using a tool (if necessary), such as a screwdriver, that allows the tape to be lifted and
removed without damaging the rim underneath.
2. Clean the inside of the rim (including the bed and walls) with a cloth soaked in isopropyl alcohol.
3. Apply the tubeless tape, spreading it anti-clockwise from the crankset side of the wheel (side opposite the brake rotor).
4. The tubeless tape should be stretched as it is applied. As a rule, it should not wrinkle or adhere to the rim bed, remaining centred/
symmetrical in relation to the width of the rim bed.
5. Apply the first strip of tubeless tape starting halfway between the second and third holes close to the valve bore, continue by
including the valve bore and then continue by making a complete loop until you reach the valve bore again.
6. After passing the valve hole for the second time, cut the tubeless tape at the second and third holes.
7. Using a cutter, cut an 'X' to open the valve bore on the tubeless tape.
8. Use the water hole on the side of the rim as a reference to align the cutter with the valve bore covered by the tubeless tape.
9. Proceed by cutting an X, with two separate movements, using a cutter with blade tip on the tape to make the first cut
10. Turning the cutter perpendicular to the previous cut, make the second cut. Make cuts carefully to avoid cutting through rim walls.
CAUTION/IMPORTANT
The entire surface of the tape must be fully bonded to the rim bed at the end of the process. Tape strips must not be raised or stuck
along the walls of the rim bed.
Cut the valve housing tape carefully to avoid cutting through rim walls.
If it is necessary to replace the sealing tape, use Reparto Corse replacement tape, together with the product in use specified in Table 2.
Table 2.
WHEEL TYPE
RC 65 SPB
TECH
RC 50 SPB
TECH
RC 50
RC 33
CERAMITEC
RC 43
CERAMITEC
*Components only available in kit form
TUBELESS VALVE
The tubeless valve is supplied by the Manufacturer. When replacing the tubeless valve, it is recommended to use genuine Reparto Corse
spare parts (part number specified in Table 1).
CAUTION/IMPORTANT
Use only valves with a suitable length and diameter. See technical specification table (Table 1).
Do not modify the valve bore.
Periodically check the tubeless valve's tightness, then check the entire system.
It is recommended that the valve be replaced at least once per year.
8
ETRTO SIZE
ETRTO 622 x 21C
ETRTO 622 x 21C
ETRTO 622 x 21C
ETRTO 622 x 21C
ETRTO 622 x 24C
TAPE CODE
C4605132 *
C4605132 *
C4605132 *
C4605132 *
C4605136 *