Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE TUBELESS VALVE
Remove the lock nut (Fig. 1 - A) that's screwed onto the exterior valve threads.
Insert the valve into the valve bore on the rim.
Screw the previously removed locknut (fig. 1 - A) back onto the valve, so that the valve is held in place relative to
the rim.
TIRES
CAUTION/IMPORTANT
RIM/TIRE COMPATIBILITY
Reparto Corse rims observe the dimensional requirements defined by ETRTO. Table 3 shows the rim/tire compatibility defined by the
European Tyre and Rim Technical Organization.
If the tire is too easy to fit on the rim, this indicates that the tire may be too big and therefore will not fit properly on the rim.
If it is difficult to mount the tire on the rime, this indicates that the rim may be too small.
Only use high-quality tires that require the use of tire levers.
Mounting the tire should require reasonable effort. Adding talcum powder to the tire will make it easier.
Table 3.
B = RIM WIDTH (mm)
21
24
WARNING/SAFETY RULE
The use of a tire that does not adhere properly to the rim can lead to sudden tire failure, resulting in serious accidents.
TUBELESS READY TIRE COMPATIBILITY CHECK
The wheels are manufactured in accordance with ETRTO dimensional standards.
Tubeless Ready tires are recommended.
CAUTION/IMPORTANT
The functionality of the Tubeless Ready System is dependent on the tires and sealant. There is no warranty for the functionality of this
system. The Manufacturer is therefore held harmless from any liability arising and/or resulting from the functionality of the Tubeless
Ready System and its compatibility with the Wheels.
CAUTION/IMPORTANT
If tubeless ready tires are installed, it is necessary to use anti-puncture sealants.
Danger of rim damage if unsuitable sealant is used.
Never use sealant containing alkaline substances (ammonia, sodium hydroxide).
23
25
28
30
32
34
• • • • • • • •
• • • • • • • • • • •
A = TIRE SECTION WIDTH (mm)
36
38
41
43
47
50
52
53
56
60
64
66
9
Publicidad
