To reinstall the door
Firmly grasp both sides of the door at the top.
. With the door set at the same angle as the
removal position (about 5 degrees from
vertical), slide the hinge arms into the hinge
slots at the bottom of the door.
. Open the door fully. If you cannot open the
door fully, the hinge arms are not properly in
the hinge slots.
Lock the hinge arms by pushing them u
against the front frame of the oven.
. Close the door, and make sure it opens and
closes normally.
Slide open the drawer until it stops.
.
Locate the roller guide clips on either side.
Take the drawer by both hands. Pull down
the left clip while lifting up the right clip to
remove the drawer.
. Clean the drawer in warm, soapy water using
a cloth or soft brush. Then, rinse and dry it
thoroughly.
Put the drawer in the roller guides on either
side, and then snap the clips into place.
English - 60