Publicidad
Idiomas disponibles
Idiomas disponibles
negative post and the vehicle chassis is
recommended. Keep the audio signal cable
away from factory wiring harnesses and
other power wiring. If you need to cross this
wiring, cross it at a 90 degree angle. Install
a fuse at the blue +12V constant wire. Fuse
installation should be as close as possible
to the battery, and no further than 18"
(45cm) of the battery, and in-line with the
harness' power cable, which is connected
to your KPX Amplifier. Make sure the power
wire is routed so that it will not be damaged,
crimped, or shorted. If you ever need to
remove the amplifier from the vehicle after it
has been installed, the ground wire should
be the last wire disconnected from the
amplifier; just the opposite as when you
installed it.
+
-
REM
L
R
L
R
GND
+12V
AMP 1
AMP 2
KPX300.4
SPEAKER
ground wire
+12V constant wire
external fuse
≤18"
≤24"
(60cm)
(45cm)
12V
English
18
Publicidad
