Publicidad
2. Remove the water reservoir lid and place it in the
storage compartment.
3. Store the device and accessories in an indoor area
protected from frost and direct sunlight.
Care and service
DANGER
Improper cleaning
Short-circuit
Switch off the device and remove the battery pack be-
fore performing any work on the device.
Do not clean the device with a hose or high-pressure
water jet.
ATTENTION
Improper cleaning
Risk of damage.
Do not use any abrasive or aggressive detergents.
The device is maintenance-free.
Cleaning the device
1. Clean the device with a moist cloth.
Cleaning the water reservoir
1. Clean the water reservoir with a moist cloth.
Cleaning the fine filter
Clean the fine filter regularly.
1. Depressurise the device, see chapter Ending oper-
ation.
2. Devices with a water reservoir: Remove the device
from the water reservoir, see chapter Water remov-
al from water reservoir.
ATTENTION
Risk of damage due to improper cleaning!
The fine filter is damaged by improper cleaning.
Fault
The device does not start
up
Device switches off auto-
matically
Cause
The battery pack is not sitting properly in
the battery mount.
The charging state of the battery pack is
too low.
The device or the battery pack is too hot
/ too cold.
The battery pack or charger is defective. 1. Replace the battery pack or charger.
The device or the battery pack
is overheated/too cold.
Clean the fine filter only under running water against its
flow direction.
Do not use sharp or hard objects such as needles or
wire brushes.
ATTENTION
Risk of damage!
The device may be damaged when operated without a
fine filter.
Do not operate the device without a fine filter or with a
damaged fine filter.
Check the fine filter for damage before installation and
replace a damaged fine filter immediately.
3. Clean the fine filter:
a Unscrew the coupling from the water connection.
b Pull the fine filter out of the water connection.
c Rinse the fine filter under running water from the
outside to the inside.
Illustration W
4. Install the fine filter in the reverse order.
Troubleshooting guide
DANGER
Touching live parts
Electric shock
Switch off the device and remove the battery pack be-
fore performing any work on the device.
Have repair work and work on electrical components
carried out by the authorised customer service only.
You can remedy minor faults using the following over-
view.
If in any doubt, please contact your authorised Custom-
er Service.
Rectification
1. Push the battery pack into the battery
mount until it audibly clicks into place, see .
1. Charge the battery pack.
1. Remove the battery pack from the device
and let it cool down, see chapter .
2. Observe the maximum ambient tempera-
ture see chapter Technical data.
3. Do not place the device and the battery
pack in the sun or operate/store them out-
side the permissible ambient temperature.
1. Remove the battery pack from the device
and let it cool down, see chapter .
2. Observe the maximum ambient tempera-
ture see chapter Technical data.
3. Do not place the device and the battery
pack in the sun or operate/store them out-
side the permissible ambient temperature.
English
21
Publicidad
