Publicidad
Fault
The device runs dry
The device is too hot or
too cold
The device draws too
much current
Warranty
The warranty conditions issued by our sales company
responsible apply in all countries. We shall remedy pos-
sible malfunctions on your device within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
Declaration of Conformity
EU Declaration of Conformity
We hereby declare that the machine described below
complies with the relevant basic safety and health re-
quirements in the EU Directives, both in its basic design
and construction as well as in the version placed in cir-
culation by us. This declaration is invalidated by any
changes made to the machine that are not approved by
us.
Product: Pressure cleaner (battery powered)
Type: K 2 Battery, OC6-18, OC 6-18 Premium
Currently applicable EU Directives
2006/42/EC (+2009/127/EC)
2014/30/EU
2011/65/EU
2000/14/EC
Harmonised standards used
EN 60335-1
EN 60335-2-79
EN 62233: 2008
EN 55014-1: 2017 + A11: 2020
EN 55014-2: 1997 + A1: 2001 + A2: 2008
Cause
The fine filter is dirty.
The supplied water quantity is too low.
The motor circuit breaker has tripped,
see chapter Motor circuit breaker.
Blockage due to foreign objects in the de-
vice or accessories.
Incompatible accessories used.
The trigger was not pulled fully.
Rectification
1. Clean the fine filter, see chapter Cleaning
the fine filter.
1. Check that the water supply requirements
are met, see chapter Establishing the wa-
ter supply.
2. Check that the device is properly connect-
ed to the water supply and vented, see
chapter Connection to a water line, Water
removal from water reservoir or Sucking
water from open containers.
3. Wait 20 s or let the device cool down be-
fore switching it on (the motor circuit break-
er has tripped, see chapter Motor circuit
breaker).
1. Allow the device to cool down or heat up.
2. Observe the maximum ambient tempera-
ture see chapter Technical data.
3. Do not place the device in the sun
or operate/store it outside the permissible
ambient temperature.
1. Remove the foreign body from the nozzle
hole of the flat jet nozzle with a needle.
2. Flush the flat jet nozzle from the front with
water.
3. Have the device checked by KÄRCHER
Service.
1. Only use accessories approved by
KÄRCHER.
1. Pull the trigger all the way to the end stop.
EN IEC 63000: 2018
Applied conformity evaluation method
2000/14/EG: Annex V
Sound power level dB(A)
K 2 Battery
Measured: 85
Guaranteed: 88
OC 6-18 (Premium)
Measured: 82
Guaranteed: 85
The signatories act on behalf of and with the authority of
the company management.
Documentation supervisor:
S. Reiser
Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Str. 28 - 40
71364 Winnenden (Germany)
Ph.: +49 7195 14-0
Fax: +49 7195 14-2212
Winnenden, 2023/08/01
Declaration of Conformity (UK)
We hereby declare that the product described below
complies with the relevant provisions of the following
UK Regulations, both in its basic design and construc-
tion as well as in the version put into circulation by us.
This declaration shall cease to be valid if the product is
modified without our prior approval.
English
23
Publicidad
