FISCHER FXC 85 Manual De Instrucciones Original página 22

Inserting the Battery
Push the charged battery into the battery holder until it
clicks into place.
Removing the Battery
To remove the rechargeable battery, press the battery
release button and pull the battery out. Do not use force
to do this.
EN The rechargeable battery has two locking levels to
prevent the battery from falling out if the battery release
button is pressed unintentionally. The rechargeable
battery is held in place by a spring when fitted in the
power tool.
Battery charge indicator
The green LEDs on the battery charge indicator indicate
the state of charge of the battery. For safety reasons, it
is only possible to check the state of charge when the
power tool is not in operation.
Press the button for the battery charge indicator or to
show the state of charge. This is also possible when the
battery is removed.
If no LED lights up after pressing the button for the
battery charge indicator, then the battery is defective
and must be replaced.
The state of charge of the battery is also displayed on
the user interface (see "Status indicators", page 26).
Battery model GBA 18V...
LED
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
Battery model ProCore 18V...
LED
5× continuous green light
4× continuous green light
3× continuous green light
2× continuous green light
1× continuous green light
1× flashing green light
22
MOAL_FXC-85.indb 22 MOAL_FXC-85.indb 22
Recommendations for Optimal Handling of the
Battery
Protect the battery against moisture and water. Only
store the battery within a temperature range of
−20 to 50 °C. Do not leave the battery in your car in the
summer, for example. Occasionally clean the ventilation
slots on the battery using a soft brush that is clean and
dry. A significantly reduced operating time after charg-
ing indicates that the battery has deteriorated and must
be replaced. Follow the instructions on correct disposal.
Assembly
Remove the battery from the power tool before carrying
out work on the power tool (e.g. maintenance, changing
tool, etc.). The battery should also be re moved for trans-
port and storage. There is risk of injury from unintention-
ally pressing the on/off switch.
Inserting/Changing the Magazine (see figure A)
Insert the magazine (12) into the power tool and allow it
to engage. To change the magazine, press the unlock-
ing lever (11) clockwise. Remove the magazine from the
power tool with a slight rotation.
Filling the Magazine (see figure B)
· Be careful when handling nails, especially when load-
ing and unloading. The nails have sharp points which
may result in personal injury.
· Only use nails that have been recommended by fis-
cher for your power tool. Using unapproved nails can
damage the power tool and cause injuries.
· During any work on the magazine, hold the power tool
in such a manner that the contact element (17) is not
Capacity
pointed at your body or at other persons.
60–100 %
30–60 %
5–30 %
0–5 %
Capacity
80–100 %
60–80 %
40–60 %
20–40 %
5–20 %
0–5 %
13.07.2023 11:23:46 13.07.2023 11:23:46