Bosch HDS252U Manual De Uso Y Cuidado página 22

Setting the Timer/s
1. Touch TIME and T[MER I will be displayed.
2. Turn countordockwiso and TIMER 2 will be displayed.
Select TIMER 1 or 2, then push TIME. SET TIMER
I (2) appears in display, Minutes flash.
Clearing the Timer/s
1. Touch TIMEonce, TIMER 1flashes,
2, Turn knob to select CLEAR TIMER 1(2),
3. Touch TIME.
4, ZfTIME pad is nottouched, range will beep and display
will continue flashing.
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii _i!i_(_!_!_i!ii!ii!ii!i_!i_;_!_i!;)_;_;_;_;_;_;_;_;_;_;_;_;_;_;_
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
i! ................................ !,,!,!,!,,!,,!,!,!,!!!!!!!!! ......
3_
Turn knob to the right to increase by ! minute
increments or left to decrease by ! minute increments,
Continue to turn knob until desired minutes are
displayed,
If setting only minutes, press START, Otherwise, continue
to stop 4.
4. Touch TIME again and the hours will flash.
When the specified time has elapsed, the control beeps.
TIMER 1 (2) END flashes in the display.
!. Touch TI_E to return to main screen.
5. Turn knob to the right to increase by ! hour
increments or left to decrease by ! hour increments
until desired hours are displayed.
6. Touch TIME again.The TIMER is now set.
If TIME or START is not touched, display will beep
andtimer will flash.
Changing the Timer/s
1, Touch Time. TIMER :_willappearin display.SelecteitherTIMER
lor2.
2. Push TIME, RESET TIMER 1 (2) appears in the
display. Minute digits flash.
3. Turn knob clockwise or counter-clockwise to change
minutes,
4. Touch TIME again and hour digits will flash.
5. Turn knob clockwise or counter-clockwise to change
hours.
6. Touch TIME and new time is set.
Page 18