Bosch HDS252U Manual De Uso Y Cuidado página 24

• The probe canbeused todeterminethe i nternal doneness
orthe"EN D"tem peratu reofmany foods, especially meats
andpoultry.
Thetemperature r ange forthe probeis !35°Fto 200°F
(57°C to 93°C).
Preheating theovenisnotrecommended when using the
probe.Ahotoven willimpair y ourability toeasily connect
theprobeto the receptacle a ndintothe meat.
Oven temperature c anbesetfor!00°Fupto450°F (38°C
upto 232°C).
INSERTING
THE PROSE
Insert the probe tipintothe food item.
Formeats, insert t he probe tipinto thethickest p art
and do not touch bone, fat, or gristle.
For large poultry" products and turkeys, insert the
probe in the thickest part of the inner thigh.
For other foods, such as a meatloaf, the probe tip
should be located in the center of the thickest part of
the food.
USING
THE PROBE
i. Prepare meat and place in roasting pan (or on rack in
roasting pan as recipe specifies). Insert the probe into
the meat (See "Inserting the Probe", above).
2. Hake sure the probe is not touching gristle, fat, bone, the
roast rack or the pan.
3. Place roasting pan with meat in cold oven on recommended
oven rack. Plug probe intothe probe receptacle. The
probe symbol will appear indisplay.
Note: The probe temperature can only be set when
the probe isinstalledin the oven°
4. Touch COOKING
MODE and selectBARE,
CONVECTION BARE or CONVECTION ROAST. The
default oven temperaturewill appear.
5. Turn knob to change temperatureif necessary.
6. Touch START.
7. Turn knob to set the probe temperature (desired end
temperature of the food).
Touch START.
8_
o
The chosen oven temperature and mode are displayed
to the right of the time.
• The probe temperature is displayed in the center to the
left of the cooking mode. It increases in 5°F
increments until the chosen temperature is reached.
The oven is preheated when the beer signals once.
When the set probe temperature is reached, END
appears in display and oven turns off, Touch OFF to
clear display.
. If probe is removed before touching OFB REINSERT
PROBE is displayed. If this happens, touch OFF.
To change only the oven temperature, touch
TEMPERATURE, OVEN TEMP will flash in the display,
Turn the knob to desired temperature and press START
twice.
To change the probe temperature, touch
TEMPERATURE, The oven temperature will flash,
Press STARTand the PROBE TE MP will flash, Turn
the knob to desired temperature and press START
again.
PROBE USE TIPS
The oven is well insulated and the retained heat will
continue to cook the meat after the oven has shut off,
For this reason, remove the meat from the oven as
soon as the control beeps.
Since meat continues to cook after being removed
from the oven, set the internal (probe) temperature 5
- !0 degrees below the desired final internal
temperature. Allow "standing time" (10 - 20 minutes)
before carving the meat.
Always use the handle of the probe for inserting and
removing. Use a potholder to remove since the probe
becomes hot.
Remove the probe from the oven when it is not being
used.
• The probe cannot be used with frozen meats. For
best results, completely thaw meats before using
the probe.
Note: Always remove probe from oven when cooking is
complete. The probe symbol will remain in the display until the
probe is removed. Do not leave probe attachment in oven during
self-dean. Oven will not self-clean with the probe installed in
the oven.
Page 20