Cutting Procedures - Hitachi Koki CM 4SB2 Instrucciones De Seguridad Y Manual De Instrucciones

English

CUTTING PROCEDURES

1. Set the machine body (base) on the
material to be cut; use the side on the base
to align the diamond wheel with the cutting
line. (Fig. 5)
2. Turn the switch ON with the diamond wheel
initially kept off the material to be cut.
The power switch is turned ON when the
trigger is pulled by one's finger, and is
turned OFF when the trigger is released.
The stopper is designed to prevent
inadvertent operation of the machine and
the trigger will not operate unless the
stopper has first been pushed in. Turn the
machine ON with the diamond wheel
initially kept off the material to be cut. The
power switch is turned ON by first
depressing and holding down the stopper,
and then pulling the trigger with one's
finger. Once the trigger is ON, the stopper
may be released and the tool may be
operated by continuing to hold the trigger.
The power switch is turned OFF when the
trigger is released.
CAUTION:
●
Do NOT use the diamond wheel for cutting along curves or at angles; otherwise, it
may be damaged, resulting in extremely shortened service life.
●
Before starting to cut, confirm that the diamond wheel has attained full-speed
revolution.
●
Should the diamond wheel stop or make an abnormal noise while operating, promptly
turn OFF the switch.
●
Always take care in preventing the power cord from coming near to the revolving
diamond wheel.
●
When finished with a job, pull out the plug from the power receptacle.
14
Base
Cutting line
Fig. 5
Guide line
on the
base
Guide line
on the base