Further Safety Instructions For All Saws - Hitachi Koki CM 4SB2 Instrucciones De Seguridad Y Manual De Instrucciones

English
23. Prior to use, be sure to check the diamond wheel in such details as crack, broken part,
bent part and the like. Don't use a diamond wheel if any of the above defect is found on
the wheel. Also confirm that no abnormality exists by actual test running.
24. Proceed with cutting operation when full speed has been reached.
25. Do NOT apply excessive force.
26. When cutting concrete, tile, or stone, the maximum cutting depth should be held to
within 25/32" (20 mm).
27. Never lay down the cutter while the diamond wheel is revolving.
Also, do not stop the cutter with the diamond wheel forcibly depressed against the
material.
28. Exercise care to position the cutter at a safe, stable spot when cutting.
29. Take good care of the power tool and keep it clean.
30. Definitions for symbols used on this tool
V ............ volts
Hz .......... hertz
A ............ amperes
no .......... no load speed
W ........... watt
........... Class II Construction
---/min ... revolutions per minute

FURTHER SAFETY INSTRUCTIONS FOR ALL SAWS

DANGER!
a) Keep hands away from cutting area and do not reach underneath the
workpiece. Contact with the wheel will result in injury.
b) Adjust the cutting depth to the thickness of the workpiece.
c) Never hold piece being cut in your hands or across your leg. Secure the
workpiece to a stable platform.
It is important to support the work properly to minimize body exposure, wheel binding,
or loss of control.
d) Never use damaged or incorrect wheel washers or bolt.
The wheel washers and bolt were specially designed for your saw, for optimum
performance and safety of operation.
Causes and operator prevention of kickback:
– kickback is a sudden reaction to a pinched, bound or misaligned wheel, causing an
uncontrolled saw to lift up and out of the workpiece toward the operator.
– when the wheel is pinched or bound tightly by the kerf closing down, the wheel
stalls and the motor reaction drives the unit rapidly back toward the operator.
Kickback is the result of saw misuse and/or incorrect operating procedures or conditions
and can be avoided by taking proper precautions as given below:
a) Maintain a firm grip on the saw and position your arms to resist kickback
forces.
Position your body either side of the wheel, but not in line with the wheel.
Kickback could cause the saw to jump backwards, but kickback forces can be controlled
by the operator, if proper precautions are taken.
8