Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
WARNING
WARNING
while spraying or while under pressure. Stop the
equipment and relieve the pressure before making
any adjustments to the wand.
WARNING
sories while under pressure. Stop the equipment and
relieve pressure before making any changes.
WARNING
scaffolding.
WARNING
cessories.
WARNING
volume.
WARNING
persons or animals.
WARNING
labels or identification tags.
WARNING
WARNING
follow instructions.
WARNING
and control of extension wand.
BEFORE EACH USE
l Read, understand, and follow ALL safety guidelines and
operation instructions prior to use.
l DO NOT bypass, disable, or remove the trigger gun.
l DO NOT use pliers, pipe wrenches, etc., to tighten. HAND
TIGHTEN ONLY!
CAUTION
wand is extended as the reaction force of the nozzle
spraying will cause the wand to flex. Make absolute-
ly certain that there are no power lines or sources of
electrical power within 10 feet of the lance at any time.
Never use near power lines.
Never extend or retract the wand
Never change nozzles or acces-
Never use while on ladders or
Never use with unapproved ac-
Never exceed rated pressure or
Never use high-pressure to clean
Never remove or alter warning
Never use wand if damaged.
Always read, understand, and
Always maintain proper ballance
Caution must be used when the
WARNING
WARNING
of a power line. Contact with power transmission lines
can cause fatal electrocution!
CAUTION
wand while spraying or while under pressure. Stop the
equipment and relieve any pressure before making
adjustments to the extension wand or changing nozzles.
TO USE THE WAND
Connect the outlet of your pressure washer to the inlet port
of the trigger gun of the wand using appropriate fittings rated
to handle high pressure. The wand may be used with one
or two lance segments. Make sure there is a nozzle in the
wand outlet before using.
TO BEGIN SPRAYING
Start the pressure washer. Raise the wand and keep the
nozzle at least ten feet away from the surface to be cleaned.
Squeeze the trigger to begin spraying. Maintain stable
footing, and move the wand in to the surface to be cleaned.
CAUTION
lease the trigger near any surfaces.
TO STOP SPRAYING
Before releasing the trigger gun, move the nozzle at least
ten feet away from the surface being cleaned and make
sure you have solid footing. The wand will rebound when the
trigger is released or if pressure is lost. When you are clear
of the work surface and in a safe area, release the trigger.
CAUTION
working on or near fragile surfaces as there may be
enough force to damage surfaces or break windows.
Keep clear of power lines.
AFTER EACH USE
WARNING
necting gun from pump hose.
l Clear the wand of water, fully retract and store in a safe
place.
Be sure all fittings are tight.
Do not use wand in the vicinity
Do not extend or retract your
In cases of emergency, do not re-
USE EXTREME CAUTION when
Relieve pressure before discon-
English | 7
Publicidad
