Publicidad
Idiomas disponibles
Idiomas disponibles
EN
The power display will display an H
when the glass surface reaches a
temperature that could cause burning.
When this risk disappears, the
is disconnected), or displays a 0
(if the appliance is still connected).
cooking time ends to make the most
of the residual heat and save on
electricity.
You can disconnect the hot plate at
any time by pressing the touch button
(1). You will hear a noise and
the power displays (10) will switch
off, except for the H residual heat
display, if necessary due to the surface
temperature.
With double and triple burner hot
plates you can use the inner ring,
or the inner and the outer rings,
depending on the size of the pan.
DOUBLE BURNER HOT PLATE ON
1 Select the desired power (from 1 to
9) by pressing touch button
(3/4). The hot plate burner display
(10) will be more bright.
2 Press the
or
(3/4) for the
chosen hot plate and then touch the
double zone
(13). The hot plate
display (14) will show
DOUBLE BURNER HOT PLATE OFF
1 Press the
or
(3/4) for the
chosen hot plate and then touch
double zone
(13). The hot
double plate display (14) will be
disappered.
20
TRIPLE BURNER HOT PLATE ON
second burner has been switched on
you touch + or - for the chosen hot
plate. Then touch
triple zone. The hot triple plate display
(15) will be shown
THE TRIPLE BURNER HOT PLATE
OFF
Press the
or
hot plate and then touch triple zone
(13). The hot plate display ( 15 ) will
be disappered.
If you repeat this step the second
burner will be disconnected and the
This function allows you to pause the
cooking process. If the timer function
is activated, it will also go into pause
mode.
1 The pans are on the cooking
level.
2 Press the Stop touch button
The power displays (10) will be
changed .Instead of the selected
cooking
or
1 Press the Stop touch button
and then any other, button. The
cooking process will resume with
the same power levels and set as
previously.
You must press the second touch
button within 10 seconds or the
function will be deactivated. The
process is not resumed after a ten
minute pause.
If due to an error one or several hot
will be automatically disconnected
after a set amount of time (see table 1).
(13) to actived
(3/4) for the chosen
has been activated, a 0 is displayed if
the glass surface temperature is not
dangerous for the user or an H if there
is risk of burning.
This function makes cooking easier
because you do not have to be
present. The touch control pre-
programmes the chosen hot plate at
the maximum power and lowers it to
the desired power (which you have
selected) after a given amount of time
(see table 2).
(12).
(12)
1 Set a hot plate to power 9 and
1
600
2
300
3
300
4
240
5
180
6
120
7
120
8
120
9
60
1
50
2
90
3
150
4
220
5
320
6
540
7
150
8
240
9
---
Publicidad
