Descargar Imprimir esta página

Teka TZ 957 Instrucciones Para La Instalación Y Recomendaciones De Uso Y Mantenimiento página 22

Encimeras vitrocerámicas touch control

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 6
EN
usual ranges allowed in power grids,
the hot plates will disconnect and a
continuous beep will be heard. The
plate displays *:
W he n the nomi n a l vo l t a g e is
reestablished, the beeping stops
and the message on the displays
disappears. The hot plates remain
disconnected and the H indicating
residual heat remains on the displays
if these were on before the surge. The
appliance is then ready to be used.
* Use pots and pans with a heavy and
* Pans with a smaller diameter than
the shown heated area are not
recommended.
* Do not slide pots and pans over the
glass because they could scratch it.
* Although the glass can take knocks
from large pots and pans without
sharp edges, try not to knock it.
* To avoid damaging the surface, do
not drag pots and pans over the
glass and keep the underneath of
them clean and in good condition.
To keep the appliance in good
22
condition, clean it using suitable
products and tools once it has cooled
down. This will make the job easier
and avoid the build-up of dirt Never
use harsh cleaning products or tools
that could scratch the surface, or
steam-operated equipment.
Light dirt not stuck to the surface can
be cleaned using a damp cloth and a
gentle detergent or warm soapy water.
However, for deeper stains or grease
use a special cleaner for ceramic hot
plates and follow the instructions on
to being burned repeatedly can be
removed using a scraper with a blade.
Slight tinges of colour are caused by
pots and pans with dry grease residue
underneath or due to grease between
the glass and the pot during
cooking. These can be removed
using a nickel scourer with water
or a special cleaner for ceramic hot
plates. Plastic objects, sugar or food
containing a lot of sugar that have
melted onto the surface must be
removed immediately using a scraper.
Metallic sheens are caused by
dragging metal pots and pans over
the glass. They can be removed by
cleaning thoroughly using a special
cleaner for ceramic hot plats (Vitroclen,
for example), although you may need
to repeat the process several times.
fig. 4
Using the scraper
Blade protected
Blade unprotected
right to make changes to its manuals
that it deems necessary or useful,
tial features.
reserves the

Publicidad

loading