Urmet 1083 Manual De Configuración página 39

19. By pressing Yes , the device's Firmware can be
step 7
updated, skip to
Update".
By pressing No, the screen closes without
updating the device.
20. The device will connect using the newly saved
configuration and the following screen will be
displayed.
21. Now press "Continue" to start testing the device.
DS1083-160A
in the chapter "Firmware
4.1. DEVICE TEST
After completing the configuration of the device run a
test to check that the device is working properly.
The test phase is the same for all video door phones.
Follow the instructions below to run a full apartment
test.
1. The following page will appear:
The test mode is characterised by presence of
one green band on the upper part of the screen
and by the indication "TEST MODE" on the
lower part of the screen, followed by the device
name and the number apartment being tested.
IMPORTANT The auto-on function will not be available
if the video door phone 1760/15 - /16 - /18 - /19 is
configured in "High rise block" mode. Go directly to
step 5
of the test.
2. Select auto-on, press the "Cameras" button and
select the device.
39