Urmet 1083 Manual De Configuración página 45

The firmware upgrade is characterised by an
orange band at the top of the screen.
13. The app will display the following screen when the
installation is complete.
14. Press the "OK" button to close the confirmation
pop-up.
15. The firmware was updated successfully. The device
has been updated to the latest version available on
the Cloud.
DS1083-160A
VIDEO DOOR PHONE 1760/15 - /16 -/18 - /19
WARNING! If the video door phone is configured in
"Apartment block" mode, it is not possible to update
the firmware via the CallMe Set app.
1. Select the "1760/15,16,18,19". button here.
The following screen will appear:
2. On the video door phone, press the
twice to display the Homepage, then press the
, , buttons and select the parameter setup
icon .
3. Select the "Advanced Settings" parameter in the
video door phone setup menu.
4. Press the button
press the button to enable maintenance mode.
5. When maintenance mode is enabled, the icon will
change to the following state
6. Select the following
appear on the display after a few seconds.
7. Press the "Scan" button to launch the QR Code
reader application on your smartphone. Scan the
QR code shown on the display of the video door
phone.
8. Press the button to confirm and return to the
main function page on the video intercom.
to select the , icon, then
.
, icon. A QR code will
button
,
45