Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting machine to power source
1
2
How to choose your pattern
EN
Attention!
Always make sure that the machine is
unplugged from power source and the
main switch is on („O") when the machi-
ne is not in use and before inserting or
removing parts.
Before connecting the power supply, make sure
that the voltage and the frequency shown on the
rating plate conform to your mains power. Place
the machine on a stable table.
1. Connect the machine to a power source as
illustrated.
2. Turn on the power switch.
3. The sewing lamp will light up when the
switch is turned on.
With the sewing machine turned off, insert the
foot control plug into its connector on the se-
wing machine.
Turn on the sewing machine, and then slowly
depress the foot control to start sewing. Release
the foot control to stop the sewing machine.
Please Note:
Consult a qualified electrician if in doubt as to
connect the machine to the power source.
Turn the stitch selection dial so that the pointer is set to the straight
stitch position. Choose your needle position, from center needle positi-
on or right needle position
Needle position right or middle possible.
(1) Stitch selection dial
(2) Stitch length dial
(3) Reverse sewing lever Handle
(4) Thread tension
Turn the stitch selection dial to
se the zigzag width by turning the dial slightly one way or the other.
The density of zigzag stitches increase as the setting of stitch length
dial approaches the „0" position. Neat zigzag stitches are usually achie-
ved at 2,5 mm or below. (2)
Please visit our website www.veritas-sewing.com/en/sarah/. There
you will find a detailed description of the individual stitch programs,
in the instruction manual.
16
or
. You can increase or decrea-
Publicidad
