Cleaning The Filter Screen; Cleaning Airless Spray Gun; Cleaning The High Pressure Filter - Titan IMPACT 1640 Instrucciones De Uso

IMPACT 1640
6.4

CLEANING THE FILTER SCREEN

A clean filter screen always guarantees maximum
i
feed quantity, constant spraying pressure and
problem-free functioning of the unit.
1. The filter screen will clog and must be cleaned at least
once a day.
2. Remove the retaining ring (Fig. 10, item 1) from the foot
valve housing (2).
3. Remove the inlet screen (3) from the foot valve housing
(2).
4. Clean thoroughly with the appropriate solvent.
6.5

CLEANING AIRLESS SPRAY GUN

Clean the spray gun after each use.
i
1. Rinse airless spray gun with an appropriate cleaning agent.
2. Clean tip thoroughly with appropriate cleaning agent so
that no coating material residue remains.
3. Thoroughly clean the outside of the airless spray gun.
6.6
i
i
1. Turn the pressure control knob counterclockwise to
2. Move the PRIME/SPRAY valve down to its PRIME position.
3. Switch the unit OFF.
4. Unscrew the filter housing (Fig. 11, Item 1). with a strap
2
5. Pull the filter cartridge (2) from the bearing spring (3).
3
6. Clean all the parts with the corresponding cleaning agent.
1
7. Check the O-ring (4), replace it if necessary.
8. Place the bearing ring (5) against the bearing spring (3).
9. Screw in filter housing (1) and tighten it as far as possible
CLEANING THE HIGH-PRESSURE FILTER
Follow these steps if you used an accessory filter
(sold separately).
Clean the filter cartridge regularly. A soiled or
clogged high-pressure filter can cause a poor
spray pattern or a clogged tip.
minimum pressure.
Unplug the power plug from the outlet.
wrench.
If necessary, replace the filter cartridge.
Slide the filter cartridge (2) over the bearing spring.
with the strap wrench.
1
2
CLEANUP
5
3
4
19