BABYTREND TS06 D Serie Manual De Instrucciones página 4

ASSEMBLY
• Attach the seat by lining up the seat
anchors on the side of the seat with
the anchors on the stroller frame
and pushing them together until they
click securely (Fig. 3e). The seat can
face in either direction, frontward or
backward.
• Carriage Mode: Make sure the
buckle strap underneath the seat
is loosend. Then loosen the recline
seat strap by squeezing the adjuster
and pulling downwards (Fig. 3f). The
carriage should be fully extended
before using.
NOTE: The footrest area should be
unbuckled (Fig. 3g).
5
Copyright © 2024, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 3e
Recline
Seat Strap
Buckle Strap
Fig. 3f
Fig. 3g
BUMPER BAR HANDLE COVER
4)
• Before attaching the bumper bar to the
stroller, wrap the handle cover around
the bar (Fig. 4a). Unwrap to remove
(Fig. 4b).
BUMPER BAR
WARNING:
Do not use
bumper bar to lift or carry seat
with child inside. The bumper
bar is not a carrying handle.
5) • Attach the bumper bar by lining up anchors
with the slots on the seat. Push until it locks
into place (Fig. 5a).
NOTE: The bumper bar must be securely
attached before using this product.
• To detach the bumper bar, press the
release button on the bottom of the bar on
each side, and pull bar out of the anchors
(Fig. 5b).
Copyright © 2024, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 4a
Fig. 4b
Fig. 5a
Fig. 5b
6