BABYTREND TS06 D Serie Manual De Instrucciones página 8

FOLD / UNFOLD
TO FOLD STROLLER
WARNING:
taken when folding and unfolding
the stroller to prevent finger
entrapment.
CAUTION:
children near stroller while folding.
NOTE: The stroller can be folded with or
without the seat installed.
15) • Before folding the stroller, push the lower
buttons on each side of the seat to disengage
from the stroller frame (Fig. 15a).
DO NOT remove with child in the stroller seat.
• To fold the stroller, press the button on the
left trigger, while pulling both release triggers
simultaneously (Fig. 15b) and push the stroller
handle toward the floor.
• Make sure the front wheels lie flat, then secure
the stroller in the folded position by locking
the fold latch, located on the right side of the
stroller, over the rivet (Fig. 15c).
TO UNFOLD STROLLER
CAUTION:
children near stroller while
unfolding.
16) • Unlock the fold latch (Fig. 16a) and unfold
stroller frame by pulling upward on the stroller
handle until the frame locks (Fig. 16b).
13
Copyright © 2024, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Care must be
Fig. 15a
1
Do not allow
Fig. 15b
Fig. 15c
Do not allow
Fig. 16a
Fig. 16b
THE INFANT CAR SEAT
WARNING:
serious injury from falling,
ALWAYS use the safety belt to
secure the car seat.
ATTENTION: CS01 EZ-Lift, CS02 EZ-Lift PLUS
and CS03 EZ-Lift PRO Infant Car Seats must
attach to the module of the strollers front
seat. These models require child tray and
2
seat back adjustment to the most reclined
position.
NOTE: To make seat position adjustments
refer to step 6d.
CS01 EZ-Lift, CS02 EZ-Lift PLUS and
CS03 EZ-Lift PRO Infant Car Seats
Align the car seat module to the inner
17) •
frame connectors. Latch the module
into the stroller frame. Underneath the
car seats handle hub, carefully align it
to the modular towers of the stroller
frame. Press down firmly for the click.
ALWAYS ensure that the car seat is
properly connected and locked onto the
stroller before each use by lifting up on
the car seat handle (Fig. 17).
REMOVING THE CAR SEAT:
• NOTE: Set handle to the carry
18)
position (Fig. 18a). Squeeze the
release handle located at the Top-
rear of the car seat and lift away
from the stroller (Fig. 18b).
Copyright © 2024, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
INFANT CAR SEAT
To avoid
Fig. 17
Fig. 18a
Fig. 18b
"Click"
Press
14