Fitting The Viewing Window/ Splinterguard - Festool TS 55 REQ Manual De Instrucciones

Before changing the saw blade, set the machine
to the 0° position and select the maximum cut-
ting depth.
Fold over the lever [5-2] to its end position.
Push up the switch-on lock [5-1] and push down
the saw unit until it engages.
Loosen the screw [5-5] using the Allen key [5-3].
Remove the saw blade [5-7].
Insert a new saw blade.
The rotational direction of the saw blade
[5-8] and machine [5-6] must be the
same!
Insert the outer flange [5-9] so that the pin en-
gages in the recess on the inner flange.
Tighten the screw [5-5] firmly.
Fold back the lever [5-2].
5
5-4
5-5
5-7
5-8
5-9
14

Fitting the viewing window/ splinterguard

The viewing window (transparent) [6-1] provides a
view of the saw blade and optimises dust extrac-
tion.
With 0° cuts, the splinterguard (green) [6-2] also
improves the quality of the cutting edge of the
sawn-off workpiece on the upper side.
Insert the splinterguard [6-2].
Screw the rotary knob [6-3] through the long
hole in the splinterguard.
Make sure that the nut [6-4] is seated securely
in the splinterguard.
6
5-1
5-2
5-3
You must bed in the splinterguard before using it:
Set the machine to maximum cutting depth.
5-6
Set the machine speed to 6.
Raise of the portable circular saw from the work-
piece, when making mitre cuts with the splinter-
guard or viewing window
Risk of injury
Always lift the splinterguard/ view window when
making mtre cuts.
[6]
6-3
6-1 6-2
WARNING
6-4