Adjusting The Base Runner; Fitting The Splinterguard; Fitting The Chip Guard - Festool TRION PS 300 EQ Manual De Instrucciones

6.2 6.1
Recommended pendulum stroke settings:
Hard and soft wood:
Wood core plywood, plywood:
Chipboard, wood fi berboard:
Plastics:
Ceramic:
Aluminum, NF metals:
Steel:

Adjusting the base runner

The base runner can be swiveled to both sides by
up to 45° for bevel cuts:
- Turn off and unplug tool.
- Remove chip guard and splinterguard.
- Release locking screw [5.1] with Allen key.
- Push base runner approx. 5 mm (1/5") for-
wards.
5.1
- Set desired inclination according to the scale
[5.4].
- Tighten locking screw [5.1].
The base runner can be moved back for sawing
close to edges.
5.2
- Turn off and unplug tool.
- Remove chip guard and splinterguard.
5.3
- Release locking screw [5.1] with Allen key.
- Push base runner to rear position so that the
5.4
centering pin [5.2] fi ts in the opening [5.3].
- Tighten locking screw [5.1].

Fitting the splinterguard

The splinterguard allows cuts with splinter-free
edges, even on the exit side of the sawblade.
- With the tool switched off and unplugged, fi t the
splinterguard [6.1] on the guide [6.2] up to the
sawblade.
- Switch the jigsaw on and with the tool running,
use the tool to push the splinterguard in and cut
on a level surface until the splinterguard is fl ush
with the front edge of the base runner.
Note: The splinterguard must lie close to the saw-
blade on both sides to ensure reliable operation.
Thus, a new splinterguard should be fi tted every
time the sawblade is changed to ensure splinter-
free cuts.

Fitting the chip guard

The chip guard prevents chips from fl ying off and
improves the effi ciency of the chip extractor.
7
1-3
1-2
1-3
1-2
0
0-2
0-1