Parkside PHP 500 D2 Traduccion Del Manual De Instrucciones Originale página 25

Gluing:
♦ Pull the trigger
to control the flow of glue in
accordance with your requirements .
♦ Apply the glue in spots . For flexible materials,
such as textiles, apply the glue in zigzag lines .
♦ Press the two workpieces to be bonded together
immediately after applying the glue and hold
for about 30 seconds . The glued bond is ready
after about 5 minutes .
♦ During breaks in work, put the glue gun down
on the plastic stand
charger .
♦ Remove any glue residue after it has cooled
down with a sharp knife . Bonded joints can be
released by heating .
Switching the appliance off:
♦ Unplug the appliance from the mains socket .
Changing the nozzles:
The temperature of the nozzle
temperature of around 200°C .
200
■ Wear protective gloves .
♦ Heat the appliance up for about 5 minutes .
Replace the nozzle
■ Risk of burns! Touch the nozzle
thermal protection
NOTE
Hold the appliance vertically with the nozzle
pointing upwards, otherwise the glue could
drip out .
■ 22 │ GB │ MT
or replace it in the
reach a
when hot .
only by the
. The nozzle tip is hot!
Maintenance and cleaning
WARNING! ALWAYS REMOVE THE
POWER PLUG FROM THE POWER
SOCKET BEFORE CLEANING THE
APPLIANCE.
■ The glue gun is maintenance free .
■ Keep the appliance clean and dry at all times .
■ Never permit liquids to enter inside the
appliance . Use a cloth to clean the housing .
Never use petrol, solvents or cleansers which
can damage plastic .
Disposal
The packaging is made from environmen-
tally friendly material and can be
disposed of at your local recycling plant .
Do not dispose of electrical ap-
pliances with normal domestic waste!
As required by European Guideline 2012/19/EU,
worn-out electrical appliances must be collected
separately and fed into an environmentally compa-
tible recycling process .
Your local community or municipal authorities can
provide information on how to dispose of the worn-
out appliance .
Dispose of the packaging in an
environmentally friendly manner .
Note the labelling on the packaging
and separate the packaging material
components for disposal if necessary .
The packaging material is labelled
with abbreviations (a) and numbers
(b) with the following meanings:
1–7: Plastics,
20–22: Paper and cardboard,
80–98: Composites
Your local community or municipal
authorities can provide information on
how to dispose of the worn-out
product .
PHP 500 D2