Dalbach HE03 Instrucciones De Uso Instrucciones De Montaje página 59

Power levels (L levels) of the energy controllers
L level Energy controller
1 Heating
2 Cooking vegetables
3 Making soup
4 Slow browning
5 Roasting meat/fish
6 Fast cooking/roasting
Connection of roasting
zone/dual-circuit hob
Switching on the hob
The heating zones are regulated by energy controllers located on the control panel of the built-
in appliance, which allow changing the regulation of heat retention (about 7% of heating
capacity) up to the maximum temperature.
Next to the energy controller or cycle switch there is a hob diagram showing the position of the
relevant hob. A light indicator shows when the hob exceeds a temperature of 50 °C (residual
heat indicator) and only goes out when the temperature falls below this temperature again.
Switching the roasting zone/dual-circuit hob
Turn the respective energy controller or cycle switch (dual-circuit zone/roasting zone) to the
right to the corresponding symbol.
4. The roasting zone/dual-circuit zone is switched on.
5. Regulate the heating performance with the energy controller.
Switching off the glass ceramic hob
Turn the energy controller to "0".
EN
Page | 59