GYS 067158 Manual De Uso página 26

Operating manual
The wheel adapter is designed to fit various truck wheels with a diameter between 600 mm and 1200 mm, and has a
maximum load capacity of 200 kg.
26
Translation of the original
instructions
USING THE WHEEL ADAPTOR
To mount the wheel adaptor to the Multitool Truck, simply:
1- Undo the clips and L-pins that are on the extension arm and
the frame, as shown in the diagram;
2- Pass the lifting chain of the wheel adaptor between the clevis
of the extension arm, then, secure it in place with the L-pin and
lock it with the R-clip;
3- Place the wheel adaptor between the clevises on the frame,
then install the L-pin and the R-clip as illustrated in the diagram.
The winch is not used to lift the wheels, so it may be advisable to
keep the winch cable out of the way.
To lift a wheel, simply pass the fork under the wheel and then use
the cylinder to lift and tilt the wheel backwards. These movements
take place simultaneously with the action of the ram.
Warning, When the pin holes are aligned, the wheel cannot be
lifted any further, so there is no need to continue to operate
the cylinder as this could damage the product.
The function of the wheel lift is to simply lift and tilt the wheel off, or
place it back on the hub.
MULTITOOL TRUCK