Sleep.8 ErgoBed 3170 Manual Del Usuario página 20

Syncing Two Bases (Optional)
A Sync Cord is included with the base. Not available on Queen, Full or
Full-Long size bases. The Sync Cord connects the two control boxes
to a single remote for the synchronization of two bases.
STEP 1
Unplug bases from power source.
STEP 2
Disconnect the Power Down Box cable from each Control Box or splitter cable. Make note
where the cable was plugged in.
STEP 3
Connect the male end of each Sync Cord to Control Box or splitter cable. Insert it into the
same port that you disconnected the Power Down Box from in Step 2.
STEP 4
Connect each Power Down Box male connection to the sync cord female connection
(refer to illustration at right).
STEP 5
Plug bases back into the power source.
STEP 6
Check to ensure all cords are securely attached. Both remotes will now operate both
bases simultaneously.
The system is now linked. Pressed buttons on either remote
will control the two bases simultaneously.
18