Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 2
Install the legs on the base.
STEP 3
Place the other end of connecting strap between the first and second section legs of the
other base, and adjust the space of the two bases. Re-tighten legs. Do not over tighten.
Use the remaining strap on other end of the base.
Troubleshooting
If one or more functions on the bed base have stopped operating:
•
Check under the bed base to verify that the wired connections are secure and that
there are no cords or bedding obstructing the movement of the base.
•
Check to ensure the green LED light is illuminated on the control box. If there is no
light, verify that the input and power cords are properly connected.
•
Unplug the base for 1 hour to reset the electronic components.
•
Plug bed base into a different electrical outlet, or test current outlet with another
working appliance (a grounded, electrical surge protector is recommended).
•
Remove and replace full batteries in the remote control and re-pair the remote to the
base (see page 15).
If issue is not resolved by following the instructions above, locate serial number on
warranty card or back of remote.
20
a
b
Publicidad
