Goodyear GY3202PS Manual De Instrucciones página 28

English • Owner´s manual
contact a service technician for repair or replacement. Do not use damaged chargers. Do not
attempt to repair the damaged battery charger to keep the tool safe.
3. Verify that the output voltage and charger connector match the proper battery, failure to do so could
result in personal injury and damage to the tool.
4. Disconnect the charger before activating the battery switch.
5. Keep the charger clean, away from humid environments and rain. Do not use the charger outdoors.
Dirt and water may cause damage to the charger and personal injury.
6. The charger is designed for use with original batteries only, other uses may be dangerous and may
cause fire or explosion.
7. Do not use damaged or malfunctioning chargers.
8. Do not use the charger on flammable surfaces (e.g. paper, wood, etc.).
9. The battery is not sold fully charged, it must be recharged for 2.5 - 3.5 hours before first use. (the LED
on the charger will turn from red to green to indicate full charge).
10. Normal charging time is 2.5 - 3.5 hours. Do not charge the battery for too long to avoid damaging
the battery. Charge the battery only when the red LED indicator on the battery is activated, this will
ensure longer battery life. will.
11. Before charging, please turn off the power switch, because when changing, it is normal for the
charger and the batteries to have high temperature.
12. New batteries or batteries that have not been used for a long time will reach the maximum capacity
after 5 charge-charge cycles.
13. Do not charge the batteries repeatedly after several minutes of operation, as this may reduce the
working time and the efficiency of the batteries.
14. Do not use damaged batteries or do not disassemble the charger or the batteries.
15. Do not charge the batteries outdoors or in humid environments.
16.With the gradual deduction of the amount of electricity from the battery, it is normal for the shear
diameter capacity to be reduced.
17. Do not use pruning shears during the charging process.
Residual risk
Keep use the tool carefully avoid risk as below:
1. Cutting or injuries due to sharp edges
2. Use for long periods of time or in incorrect positions may cause damage.
ATTENTION!
The equipment will bring electromagnetism; it can interfere with some medical device in body. It is
suggested to ask for doctor before the usage of the tool by at the same time with medical devices.
WARNING!
Don't touch blade when the battery is connected to the tool.
Keep a minimum distance of 15cm between the blades and any part of your body.
Keep other people at a minimum distance of 1.5m.
28