Publicidad
Idiomas disponibles
Idiomas disponibles
English • Owner´s manual
pruning shear enters into working mode.
6. Auto power off mode: when it is in standby mode and is 5 minutes without use. The buzzer will
sound for a long time. To return to work mode, press twice in succession.
7. Low battery reminder: When the battery is low, the green indicator light flashes to remind you to
replace the battery pack. When the battery recovers, the green light stops flashing.
8. Storage: After use, remove the lithium battery pack and clean the blade.
ATTENTION!
Don't sway the pruner from the left to right in order not to damage the edge of blade during the
resume process of blade. Check the working frequency of the blade in order to verify the good
working condition.
Cutting procedure
Risk of cutting and severe injuries.
Wear protection gloves.
Wear suitable work clothes such as boots with non-slip soles, sturdy long trousers, gloves and
goggles.
Wear eye protection.
1. When ready to cut, place the blade on the branch to be cut and press the trigger.
2. When operating the tool, keep the other hand and any other part of your body at a minimum
distance of 15cm from the blade.
3. Keep all other people at a minimum distance of 1.5m.
4. Blade will be hurt or jammed if cutting bigger branch forcedly.
5. Don't move the tool during the pruning shear cutting, it can cause danger.
6. Don't use the device in rain or humidity environment.
7. During storage of the device after use, take off wire from battery and pruning, shut up power switch
before storage.
ATTENTION!
Please check battery charge level or blade sharpening when cutting is difficult or not smooth.
6. MAINTENANCE AND CLEANING
Faulty tools must be repaired by the authorized technical service. Use only original parts, this will ensure
the correct operation of the tool.
31
Publicidad
