Goodyear GY3202PS Manual De Instrucciones página 30

English • Owner´s manual
After hearing the double beep, it means that the battery is powered normally.
2. Press the latch twice in succession. The blade will open automatically.
3. Before starting to work with the machine, press the latch several times and observe how the blade
operates. If you detect any strange phenomena (sound, abnormal and non-progressive speed); keep
pressing until its operation is normalized.
4. To put the scissors in standby press the trigger for 4 seconds until you hear the beep. The blade will
close automatically.
5. To turn the scissors off, press the on/off button for 3 seconds until you hear the beep sound.
ATENTION!
To ensure that the blades are closed when the scissors are switched off, steps 4 and 5 must be carried
out in order. Otherwise, the scissors will shut down with the blades open.
Functional description
The tool is made of high-strength materials. The quality blades and lightweight design make it easy to
use with one hand. The cut is precise and progressive, it does not damage the plant. In case of danger or
malfunction release the trigger and the blade will return to its initial opening position. Keep this consi-
deration in mind to avoid accidents, damage or unwanted injuries.
Working environment
-Keep temperature of environment at 4°C - 40°C when charging battery.
- Keep the temperature of the tool between -10°C and 50°C while working.
-Do not use in explosive atmosphere or near flammable substances or gases.
-Do not use in case of rain or on wet branches.
Initial work procedure
ATENTION!
Please wear suitable cloth and gloves when operate this tool. Always check tools before use, make
sure on/off switch and safe switch are all ok. The power should be put off when you loosen the
trigger. Stop using the tool in case of switch failure. Always check rated voltage of battery match
pruning shear.
WARNING!
It may take some time for the blade to stop. Do not touch the blade while it is moving to
avoid risk of injury or accident.
1. Large opening selection: Release the trigger, turn on the power switch, and after hearing 2 warnings,
press the trigger twice continuously.
2. Small aperture selection: Press the trigger and at the same time turn on the power switch, and after
hearing 1 warning, press the trigger twice continuously.
3. Standby mode: Press the trigger, the blade closes, hold the trigger for 5 seconds, the buzzer will
sound once and enter standby mode. To return to work mode press twice in succession.
4. During the cutting process, if the cutting blade encounters a branch that it cannot cut, it will lock and
stop, release the trigger to return to the open position, after which the next cut can be carried out
normally.
5. Automatic standby mode: After no operation for 3 minutes in working mode, it automatically enters
into standby mode, the buzzer sounds, and the trigger needs to be reset twice in a row, and the
30