Goodyear GY3202PS Manual De Instrucciones página 36

English • Owner´s manual
11. PROBLEMS AND SOLUTIONS
PROBLEM
Pruner doesn't start.
Intermittent operation.
Hot blades.
Poor trimming
performance.
Will not charge. Charger
red light flashes.
36
POSSIBLE CAUSE
Battery out of charge.
Battery not connected.
Safety switch cannot be initiated.
On / off switch failure.
Loose internal connections..
On / Off switch failure.
Blade dull.
Blade gap.
Poor lubrication, resulting in excessive friction.
Lubrication is not in place, resulting in excessive friction. Lubricate blade.
Dirty blade.
Blade dull.
Trimming quality is poor.
The battery is not fully charged.
The battery is not properly placed in the charger
The battery charger is not connected properly to the
power supply.
Battery contact point is dirty.
Invalid battery.
Battery charger is invalid.
SOLUTION
Charge Battery.
Connect battery.
Open by initiating safety on
switch.
Send to repair service center.
Send to repair service center.
Sharpen or replace the blade.
Sharpen or replace the blade.
Lubricate blade.
Clean blade.
Sharpen or replace the blade.
Read the instructions carefully.
Charge the battery.
Insert the battery correctly.
Connect properly.
Clean the battery contacts.
Replace battery.
Replace battery charger.