Velleman VDP150CC1 Manual página 3

5. Use
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This digital
start address is the channel number from which the device "listens" to the digital commands from the DMX controller.
The start address/channel number is set by means of the DIP switches located at the back of the device.
You can set the same start address for a whole group of devices or enter an individual one for every device.
When using one single address, all the units will "listen" to the control signal on one particular channel. In other
words: changing the settings of one channel will affect all devices simultaneously. If you set different addresses,
each device will "listen" to a separate channel number. Changing the settings of one channel will only affect the
device in question.
In the case of the VDP150CC1, a 1 channel device, you will have to set the start address of the first unit to 1, the
second unit to 2 (1 + 1), the third unit to 3 (2 + 1), and so on. The DMX start address is defined by the DIP switches.
The encoding is binary: DIP switch 1 has value 1, switch 2 has value 2, switch 3 is 4, switch 4 is 8, etc.
For example, if the start address were 95, the settings would be 111110100 (1+2+4+8+16+0+64+0+0=95).
Channel configuration
CHANNEL 1: 7 colours + white
It is possible to link multiple units for synchronous operation by means of the enclosed DMX cable.
You can use the remote control to switch the lamp on or off immediately. The remote control only affects the lamp,
not the whole device.
To make the device operate in music-controlled mode, set all DIP switches to OFF. Adjust the sound sensitivity of the
built-in microphone by means of the knob on the rear panel of the device until the colour of the beams and their
reaction to the music satisfy you.
6. Cleaning and Maintenance
1. All screws should be tightened and free of corrosion.
2. The housing, the lenses, the mounting supports and the installation location should not be deformed, modified or
tampered with e.g. do not drill extra holes in mounting supports, do not change the location of the connections, ...
3. Mechanically moving parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts, apart from the lamp and the fuse (see "4. Installation" on p.2).
8. Contact your dealer for spare parts if necessary.
7. Technical Specifications
Power Supply
Power Consumption
Fuse
Dimensions
Total Weight
Lamp
Max. Ambient Temperature
The information in this manual is subject to change without prior notice.
VDP150CC1
max. 230VAC/50Hz
max. 150W
F 3A, 250VAC (5 x 20mm) (order code FF3N)
170 x 130 x 205mm
3.2kg
15V / 150W EFR GZ6.35 (order code LAMP150/15)
45°C
3 VELLEMAN