GE P2S975 Manual Del Propietário página 13

Usingthe clock, timer and range lock-out. CEApplia,ce .com
To Set the C/ock
[ CLOCK
Make sure the clock is set to the
correct time of day.
Tile clock must be set to tile correct time
of day for tile automatic oven timing
tractions to work properly: Tile time of
day cannot be changed during a timed
baldng or self'cleaning cycle.
[77 Touch
tile CLOCK pad.
[_] Touch tile nmnber pads.
[_] Touch tile
START
pad.
I KITCHEN 1
i T MER J 171
ON/O_F
The timer is a minute timer only.
The timer does not control oven
operations, The maximum setting on
the timer is 9 hours and 59 minutes.
To Set the Timer
Touch tile KITCHEN TIMER
ON/OFF pad.
Touch die nmnber pads tmdl die
_t[noLlnt of
dine you
want sho_,vs
in tile display. For example, to set
2 hems and 45 minums, touch 2, 4
and 5 in that order ff you make a
mistake touch the KITCHEN TIMER
ON/OFF pad and begin again°
_] Touch tile
STARTpad.
After touching theSTART pad,SETdisappears,
this tellsyouthetimeis counting down,although
thedisplay doesnotchange untiloneminutehas
passe_Seconds will notbe shownin thedisplay
untilthelast minuteiscounting down.
[_ When tile diner reaches
:00, tile
control will beep 3 times ff)llowed
by one beep eve_ T 6 seconds until
tile KITCHEN TIMER ON/OFF pad is
touched.
The&second tonecanbe canceled & following
thestepsin theSpecial f eaturesof youroven
control s ectionunderTones a t theEndof a
timedCycle.
ToReset the Timer
If die display is still showing die time
remaining, you may change it by
touching tile KITCHEN TIMER ON/OFF pad,
then touch tile nmnber pads until tile
time you want appears in tile display.
If die remaining dine is not in die display
(clock, delay start or cooldng time are in
the display), recall tile remaining time by
touching
the KITCHEN TIMER ON/OFF pad
and then touching tile number pads to
enter the new time you want.
To Cancel the Timer
Touch tlle KITCHENTIMERON/OFF
pad twice.
RANGE
]
LOCK-OUT J
J LOCK/UNLOC_
]l
I HOLD 3 SECONDS j
Range Lock-Out (on some models)
Your c ontrolwill allowyoutolockoutthesurface
burners, o venburners andcontrol p anelsothey
cannot b e activate_
To lock/unkmk tile controls:
%
%
Turn all smf_me burne,_ off.
Touch and heM tile RANGE
LOCK-OUTpadfor 3 seconds undl
tile display shows LOCON.
To unlock tile control, touch and
heM tile RANGELOCK-OUTpad for
3 seconds until tile display shows
LOCOFF.
When dlis featme is on and die touch
pads are touched, tlle conuol will beep
and the display will show LOCON.
The controllock-out m odeaffectsall controls.
Nocontrolswill workwhenthisfeatureis
activated.
The adjustment w i//be retainedin memory
aftera powerfailure.
13