GE P2S975 Manual Del Propietário página 36

Before you call for service...
Troubleshooting tips
Possible Causes What To Be
Ciock and timer do Plug on range is not completely * Make sure electrical plug is plugged into a live, properly
not work inserted in the electrical outlet, gq ounded outlet.
A fuse in your home • Replace the fuse or reset the circuit breaker
may be blown or the
circuit breaker tripped.
Oven controls improperly set.
. See the Using the clock and timer section.
Oven will not self=clean
Surface burner
is on. . Turn all surface burners off
The oven temperature is * Allow the range to cool and reset the controls.
too high to set a self-clean
operation.
Oven controls improperly set. • See the Using the self-cleaning oven sectkm.
The probe is plugged into * Remove tile probe flom the oven.
the outlet in the oven.
"Crackling" or This is the sound of the * This is normal.
"popping" sound
metal heating and cooling
during both the cooking and
cleaning functions.
Excessivesmoking
duringa clean cycle
Excessive soil.
* Touch the CLEAR/OFFpad. Open the windows to
rid the room of smoke. Wait until the LOCKED light
goes ore Wipe up the excess soil and reset the
clean cycle.
Ovendoor will not
Oven too hot. • Allow the oven to cool below locking temperature.
open after a clean cycle
Oven not clean after a
Oven controls not properly set.
* See the Using the self-cleaning oven sectkm.
clean cycle
Oven was heavily soiled. * (;lean up heavy spillovers before starting tile clean
cycle. Heavily soiled ovens may need to selfXclean
again or fbr a longer period of dine.
"LOCKED"flashes
The self-clean cycle has been * (;lose tile oven door.
in the display selected but the door is not
closed.
"LOCKED"light is
The oven door is locked * Touch the CLEAR/OFFp'ad. Allow the oven to cool.
on when you want
because the temperature
inside the oven has not
dropped below the
locking temperature.
"F--'and a number
or le#er flash
in the display
You have a function error code. * Touch the CLEAR/OFFpad. Put file oven back into
operation.
If the function code repeats. * Disconnect all power to the range fbr at least 30
seconds and then reconnect power. If the flmcdon
error code repeats, call fbr service.
36