Tunturi PLATINUM UB20 Manual Del Usuario página 21

Explanation of buttons
Turn dial button clockwise (up)
- Increase resistance level
- Setting selection�
Turn dial button counter-clockwise (down)
- Decrease resistance level
- Setting selection�
Press dial button (mode/ enter)
- Confirm setting or selection�
- Stop display scan function, and fix current parameter in centre
display�
- Go to next parameter when being in Fixed display mode�
NOTE
• When stopped the scan mode by fixing a specific parameter,
there is no way to activate the "scan" function again, other than
quickly press "Start/ Stop" twice to rapidly pause and restart
your workout again�
Handlebar-grip + button
Same function as if turning dial knob in clockwise direction
Handlebar-grip - button
Same function as if turning dial knob in counter clockwise direction
Reset
- In setting mode, press RESET key once to reset the current function
figures�
- Press RESET key and hold for 3 seconds to reset all function figures
Start/ Stop
- Start or Stop workout
Body Fat
- Test body fat% and BMI in stop mode�
Recovery
- After the console detects pulse signal, press the RECOVERY key to
enter recovery mode to monitor heart rate recovery ability
Operation
Power on
- Plug in power supply to power on computer�
- Press any key to power on the console when being in sleep mode��
- Start pedalling to power on the console when being in sleep mode�
NOTE
• The console switches to sleep mode when the equipment is not
used for 4 minutes�
Sleep mode
When the console is in sleep mode, all information windows are
blacked out as if it is in off mode�
Power off
- To power off the trainer it is required to remove the power source
from the trainer�
Workout selection
Use dial button function to select:
M Manual
P1 ~ P12 Program profile 1 ~ 12
Heart rate control
W Watt control
U User program
USB function
The user can connect their device to charge during workout�
Voltage/ Current: 5VDC/ 1.0 Amp
Programs
Quick start
- Press START/ STOP key to start your workout without any pre-set
setting�
- Use dial button function to adjust resistant level during workout�
End or Pause your workout
- Press START/ STOP in workout mode to stop/ pause your workout.
To resume your workout press START/ STOP button in pause
mode�
- Press RESET key ( in Pause mode ) to reset all workout data�
- Press and hold RESET key for over 3 seconds to reset console� (
Active training data will be lost )
QUICK TIP
• When being in Pause mode, you can use the "Dial button" to
adjust your set goals�
• Press dial button to select: Time/ Distance/ Calories and or
Pulse�
• Turn dial to set the goal as preferred, and press "Mode" to
select first next parameter to change if required, or press "Start/
Stop" button to resume workout�
Set user
A user can be selected when console is in "Start up"mode�
When console is in functional mode, Press and hold "RESET" key for
over 3 seconds, to restart console and turn to "Start up' mode�
You see "U1" blinking ( or last selected user U1~U4).
- Select user, turn dial to select U1~U4,
confirm by press dial button�
- Select Gender, use dial button to select
confirm by press dial button�
- Set Age ( A ), use dial button to select
Setting range: 1 ~ 99 (±1),
confirm by press dial button�
- Set Height ( H ), use dial button to set
Setting range: 100~200 cm (±1),
confirm by press dial button�
- Set Weight ( W ), use dial button to set
Setting range: 20~150 kg (±1),
confirm by press dial button�
NOTE
• Setting correct user parameters is required for the :
1� Correct heart rate target program functionality�
2� Correct body fat en BMI measurement function�
• Selecting a user determines what "User programs" will be
loaded� See "User Program"
2 1
English
(Male)/ (Female),