Fueling; Information Before You Start - Stihl BR 350 Manual De Instrucciones

Fueling

Preparations
Before fueling, clean the fuel filler cap
and the area around it so that dirt cannot
fall into the tank.
Thoroughly shake up the mixture in the
canister before fueling your machine.
To avoid the risk of burns or other
injuries due to escaping gasoline
vapors, open the fuel filler cap
carefully so that any excess
pressure in the tank can escape
slowly.
Never use a tool to open the
bayonet catch. This could damage
the cap and cause fuel to leak out.
Do not spill any fuel and do not fill the
tank up to the brim.
BR 350, BR 430
Open the fuel filler cap
1.
2.
Press the cap down with your hand
N
as far as possible, turn it
counterclockwise (approx. 1/8 turn)
and remove it.
Fueling
Take care not to spill fuel while fueling
and do not overfill the tank.
Close the fuel filler cap
1.
2.
Fit the cap and turn it until it
N
engages in the bayonet mount.
Press the cap down with your hand
N
as far as possible and turn it
clockwise (approx. 1/8 turn) until it
engages completely.
Information Before You
Start
With the engine stopped and
before starting, check the air
intakes between the backplate
and powerhead for blockages and
clean if necessary.
Positions of setting lever – BR 350
1
2
Run position F
Engine runs or is ready to start. Throttle
trigger (2) can be moved to any position.
Switch off engine †
Ignition is interrupted, engine stops. The
setting lever (1) is not locked in this
position. It springs back to the run
position F. The ignition is switched on
again.
English
15