Storing The Machine - Stihl BR 350 Manual De Instrucciones

English
Release the rope rotor.
N
Release the rope slowly so that it
N
winds onto the rotor.
The starter grip must locate firmly in the
guide bushing. If the grip droops to one
side: Add one more turn on the rope
rotor to increase spring tension.
When the starter rope is fully extended it
must still be possible to rotate the rotor
at least another half turn. If this is not the
case, the spring is overtensioned and
could break.
Take one turn of the rope off the
N
rotor.
Replacing a Broken Rewind Spring
The bits of spring may still be
under tension and could fly apart
when you take them out of the
starter cover – risk of injury –
wear face protection and work
gloves.
Removing the rope rotor
N
Use a screwdriver to carefully
N
remove the spring housing (1) and
the parts of the broken spring.
Lubricate the new spring with a few
N
drops of non-resinous oil.
24
Position the replacement spring
N
with spring housing in the starter
cover.
Fit the rope rotor, tension the rewind
N
spring, fit the starter cover and
secure it in position.

Storing the Machine

For periods of 3 months or longer
Drain and clean the fuel tank in a
N
well ventilated area.
Dispose of fuel properly in
N
accordance with local
environmental requirements.
Run the engine until the carburetor
N
is dry – this helps prevent the
carburetor diaphragms sticking
together.
Thoroughly clean the machine –
N
pay special attention to the cylinder
fins and air filter.
Store the machine in a dry, high or
N
locked location, – out of the reach of
children and other unauthorized
persons.
BR 350, BR 430