Assembling The Unit - Stihl BR 350 Manual De Instrucciones

English

Assembling the Unit

The combination wrench and
screwdriver are in the supplied
accessory bag.
BR 350 Blower Tube
Fitting the pleated hose on the elbow
1
Ease the slip ring (2) apart and push
N
it over the elbow (1).
4
3
Open the hose clamp (3) and fit it on
N
the pleated hose (4).
Close the hose clamp (3) – engage
N
tab in recess.
10
2
Push the pleated hose (4) over the
N
slip ring (2) as far as stop.
Position the hose clamp (3) as
N
shown in the illustration.
2
Tighten down the screw (arrow).
N
Mounting the blower tubes and
nozzle
5
Assemble the blower tubes (5) and
N
nozzle (6).
Mounting the control handle
3
4
N
N
Adjusting the control handle
N
N
6
5
N
N
3
7
Pull the ends of the clamp on the
control handle (7) apart and push it
over stub of pleated hose (4).
Attach throttle cable to retainer on
the hose clamp (3).
Put the machine on your back and
adjust the harness – see "Fitting the
Harness".
7
Push the blower tube (5) into the
stub of pleated hose (4) as far as
the stop.
Move the control handle (7) along
the tube to the most comfortable
position.
Tighten down the screw in the
control handle (7).
BR 350, BR 430
5