Villeroy & Boch ViClean-I 100 Guía Rápida página 24

Note
The power and water supplies must be switched off before installation.
Make sure that installation has completely finished before connecting the ViClean to the power and water
•
supplies.
Make sure that the connection parts of the water supply hose are not damaged.
•
Use the ViClean solely in a line pressure range between 0.1 MPa (dynamic) and 1.0 MPa (static),
•
data", Page 23.
Use the ViClean solely in a water temperature range between 10 °C and 35 °C,
•
The ambient temperature must be between 15 °C and 40 °C,
•
At a water hardness of N 2.4 mmol/l (N 14°dH), we recommend the use of a central water softening system to
•
ensure a long service life. You can find out the water hardness from your local water supplier.
There can be a small quantity of water still inside the product due to the water flow test carried out in the factory.
•
This water does not, however, constitute a product defect.
Note
These instructions describe the installation of ViClean with ViConnect. If you intend to
use an installation system from another manufacturer, read the respective instructions.
Installation dimensions, see "installation requirements", Page
Installation instructions, see Page
24
394.
see "Technical data", Page
see "Technical data", Page
391.
M.VILLEROY-BOCH.COM // V 1.0 // 17.02.2023 // 48877
see "Technical
23.
23.