Harken INTCLHRW500KIT Manual De Instrucciones página 48

Cleaning
Often wash the Winch and its accessories with fresh water and allow them to dry naturally and away
from direct heat.
Do not allow cleaning products or other cleaning substances containing caustic solutions to come into
contact with the Winch and its accessories, especially with anodised, chrome-plated or plastic parts.
Do not use solvents, polishes and abrasive pastes on the logos and stickers on the Winch.
20. PACKAGING, TRANSPORT, AND STORAGE
Each Winch is supplied by Harken in its original packaging in order to prevent dust and dirt and
potential damage. Check the integrity of the packaging and if it is damaged, before using the Winch,
carry out a thorough inspection. Store the Winch in a dry, ventilated place, with low humidity and not
in a saline environment to avoid corrosion and protect the product from impacts, chemical reagents or
possible damage that could reduce the useful life or affect the performance of the Winch.
Keep away from extreme temperatures: below -10°C or above +50°C.
Excessive heat can deform some components.
Extreme cold can damage any fragile materials and cause the lubricating products to freeze.
Use the original packaging for transport and storage.
NOTE!
When positioning the Winch on the ground, gently place it on the floor, to avoid damaging machine
parts.
21. DISPOSAL
When disposing of the machine, it is appropriate to separate the different materials for subsequent
re-use or separate disposal.
The waste material must be disposed of in such a way as not to present any risk to the operators' health
and safety.
22. ATTACHMENTS
The following attachments are an integral part of the Manual:
- CE Declaration of Conformity
- Dynamic operational test Par.6.3.2.3 EN 13157:2009 (the test certificate is indicated on the label on
the Winch box)
The technical documentation attached to this Manual must be considered its integral part.
48 22/06/2023