Descargar Imprimir esta página

cecotec FAST&FURIOUS 8060 ULTRA Manual De Instrucciones página 10

Centro de planchado

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
physical, sensory, or mental capabilities, or lack of experience
or knowledge, unless they have been given supervision or
instruction concerning the use of the appliance in a safe way
by a person responsible for their safety, and understand the
hazards involved.
Place the appliance on a dry, stable, flat, heat-resistant surface.
The temperature of accessible surfaces may be high while in
use and could cause burns.
Do not touch hot surfaces while in use or immediately after.
Unplug the appliance immediately if fire or smoke is observed.
Do not leave the appliance unattended while in use. Unplug it
from the mains supply when you finish using it or when you
leave the room.
The appliance must not be plugged in when filling or emptying
the water tank.
Check the power cord regularly for visible damage. If the cord is
damaged, it must be replaced by the official Technical Support
Service of Cecotec, in order to avoid any type of danger.
The tank cap must not be open when the appliance is switched
on.
The use of tap water is recommended. If the lime content of the
tap water is too high, use a mix composed by 50 % of tap water
and 50 % of water with low mineral content. Do not use only
water with low mineral content.
Burns can occur when touching hot metal parts, hot water,
or steam. Hot water may leak from the iron. Be careful when
filling or turning the steam iron upside down.
To protect against burns or injuries, do not direct steam toward
persons or animals when ironing.
The device must be used and placed on a stable surface. When
placing the iron on its stand, make sure that the surface is
stable.
05537_Fast&Furious 8060 Ultra_Manual_YV_01200601.indd 10
05537_Fast&Furious 8060 Ultra_Manual_YV_01200601.indd 10
2/6/20 16:42
2/6/20 16:42

Publicidad

loading

Este manual también es adecuado para:

05537