cecotec FAST&FURIOUS 8060 ULTRA Manual De Instrucciones página 39

Connect the plug to a wall outlet, the temperature indicator and the indicator of MAX. steam-
power level will turn on.
Turn temperature knob to select the desired temperature setting depending on the garment's
fabric, and the iron will start heating up.
When the selected temperature is reached, the temperature indicator will turn off.
Then, the iron is ready to be used.
Warning: Do not touch the soleplate before it cools down!
Steam ironing
Grasp the water tank's handle to remove the water tank, then fill it with water through the
filling opening. Use purified water with few calc particles. After this, replace the water tank
properly. The max. capacity of the water tank is 1.8L, the water level should not exceed the
MAX mark.
Place the steam station on the thermal insulation stand of the unit base.
Connect the plug to the wall outlet, press the power switch, and the low-steam power level
indicator will flash. There are three steam-power levels: Low, Medium and High. Select the
appropriate steam power level for each garment. Make sure there is enough water in the water
tank.
Turn the temperature knob to the desired setting taking into account the fabric, the temperature
indicator will turn on. The steam station will start emitting heat. Refer to "ironing tips" and
"additional table" below when setting the temperature.
The water in the steam generator will be heated after a few minutes, then the temperature
indicator will switch off. This indicates that the soleplate temperature has achieved the
selected temperature.
When the indicator light of the operating steam-power level changes from flashing to steady,
it indicates that the iron is ready to use.
Then, press the steam trigger gently for steam to be sprayed from the soleplate continuously.
Warning: Never direct the steam at people!
After ironing, press the power switch for about 2 seconds, the appliance will switch off and
with it, all the indicators. Remove the plug from the wall socket. Be careful, the soleplate will
still be hot, never touch it with your hand.
Place it on the heatproof stand until it cools down completely.
Ironing tips
Always check first whether a label with ironing instructions is attached to the article. Follow
these ironing instructions in any case.
The iron heats up quicker than it cools down; therefore, start by ironing the articles that require
the lowest temperatures such as those made of synthetic fiber.
If the fabric consists of various kinds of fibers, always select the lowest ironing temperature to
iron the composition of those fibers.
Silk and other fabrics that are likely to become shiny should be ironed on their inner side.
05537_Fast&Furious 8060 Ultra_Manual_YV_01200601.indd 39 05537_Fast&Furious 8060 Ultra_Manual_YV_01200601.indd 39
ENGLISH
FAST&FURIOUS 8060 ULTRA
39
2/6/20 16:42 2/6/20 16:42