Publicidad
Idiomas disponibles
Idiomas disponibles
DC Inverter U-match Series Floor Ceiling Type Unit
(1). Disassembly method of filter screen and electric box cover
1. Open the air inlet grille
① . Firstly unfix two buckles on the grille as shown
on the picture.
② . Remove the screws under the buckles by a
screwdriver and then open the inlet grille.
2. Clean the filer screen
Clean the filer screen by a vacuum cleaner or
wash it by flashing water. If the oil stain on the filter
can not be removed or cleaned up, wash it by warm
water meld with the detergent. Dry the filer in the
shadow.
Note:
① . Never use hot water over 45°C in case of color
fading or turning yellow.
② . Never dry it by fire so as to prevent the filter
caught fire or deformation.
3. Disassemble the left and right side board
① . After the grille is removed, use a screwdriver to
remove the screws shown on the picture.
② . Push the side plate as per the arrowed direction
and take it down.
4. Disassemble the right side board
5. Disassemble the electric box cover
After the right side board is removed, the electric
box cover will be shown up and disassemble the
fixed screws on it.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Remove the screw
Remove the screw
Disassembly method of right side board Step 3
27
Publicidad
