Descargar Imprimir esta página

Gree Serie Manual De Instalación página 27

Publicidad

Idiomas disponibles

Idiomas disponibles

DC Inverter U-match Series Floor Ceiling Type Unit
37
38
39
40
41
42
43
44
45
Note: When the unit is connected with the wired controller, the error code will be simultaneously
shown on it.
(2). Instructions to the Error Indicating Lamps on the Panel of the Floor Ceiling Type Unit.
States of the Indicating Lamps:
Indicating Lamp of "POWER": The indicating lamp will
① .
shine when power on, while it will go out when power off.
Indicating Lamp of "COOL" :
② .
The indicating lamp will shine when "COOL" is activated,
while it will go out when "COOL" is deactivated.
Indicating Lamp of "HEAT":
③ .
The indicating lamp will shine when "HEAT" is activated,
while it will go out when "HEAT" is deactivated.
Indicating Lamp of "TIMER":
④ .
The indicating lamp will shine when "TIMER" is activated,
while it will go out when "TIMER" is deactivated or the set.
6.2 Working Temperature Range
Test Condition
Nominal Cooling
Nominal Heating
Rated Cooling
Low Temp. Cooling
Rated Heating
Low Temp. Heating
Note:
The design of this unit conforms to the requirements of EN14511 standard.
① .
The air volume is measured at the relevant standard external static pressure.
② .
Cooling (heating) capacity stated above is measured under nominal working conditions
③ .
corresponding to standard external static pressure. The parameters are subject to change with
the improvement of products, in which case the values on nameplate shall prevail.
In this table, there are two outside DB values under the low temp cooling conditions, and the
④ .
one in the brackets is for the unit which can operate at extreme low temperature.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
PA
Pc
Pd
Sensor connecting protection
PE
Temperature drift protection
PL
PH
PU
PP
ee
Indoor Side
DB(°C)
27
20
32
21
27
20
AC current protection
Drive current error
Bus low voltage protection
Bus high voltage protection
Charge loop error
Input voltage abnormality
Drive memory chip error
Table 11
WB(°C)
19
23
15
25
Fig.36
Outdoor Side
DB(°C)
WB(°C)
35
7
48
-15
24
-10
24
6
18
-11

Publicidad

loading